When an oil boiler stops in cold weather, the cause is often the fuel supply rather than the boiler itself: a low tank, a blocked filter, water in the tank, or oil thickening in an exposed pipe during a hard frost. Some of these you can check safely yourself, but anything involving the burner or fuel line is a job for an OFTEC registered engineer. Our oil boiler engineers look after off-grid homes around Henley-on-Thames, from villages like Nettlebed up in the Chilterns down to the Thames valley.
The most common cold-weather culprits
Oil boilers are reliable, but winter puts the whole fuel system under more strain. The usual problems are:
- Low oil: the tank empties faster when the heating runs all day, and the last few inches may contain sludge.
- Blocked filter: sediment or wax can clog the filter between the tank and the boiler.
- Water in the tank: condensation or a damaged lid can let water in, which can cause running problems.
- Thickened oil: in very low temperatures, kerosene can start to form wax and flow less freely through exposed pipes.
- Burner faults: worn nozzles, electrodes or pumps often show themselves when the boiler is working hardest.
Safe checks you can do
Before you call anyone, it’s worth checking:
- The tank level. Look at the gauge or monitor. If it’s very low, order more oil.
- The power. Make sure the boiler’s switched on and no fuse has tripped.
- The controls. Check the thermostat, timer and any programmer are calling for heat.
- The tank itself. Look for cracks, splits, leaks or a loose lid.
- The reset. If the boiler shows a lockout light, you can press the reset once, following the instructions on the boiler.
If it locks out again, stop there. Repeated resets can flood the combustion chamber with oil and make the problem worse.
What to leave to an engineer
Some jobs need an OFTEC registered technician with the right tools:
- Bleeding air from the fuel line after the tank has run dry
- Changing or cleaning oil filters
- Draining water from the tank
- Servicing or replacing the nozzle, electrodes or pump
- Investigating smoke, soot or smells of oil or fumes
Don’t remove boiler panels or adjust the burner yourself. If you notice smoke, a strong smell of fumes inside or your carbon monoxide alarm sounds, switch the boiler off, open windows and get everyone out, then call for help.
Preventing problems before they happen
An annual service catches most issues before they leave you without heating. During an oil boiler service, the engineer typically checks combustion, cleans the burner and heat exchanger, replaces the nozzle if needed and checks the filter. Our service and repair page covers what we look at.
A few other habits help:
- Reorder oil well before the tank gets low
- Keep the tank lid secure and the area around it clear
- Think about insulating exposed fuel lines if your boiler often stops during hard frosts
- Note any change in how the boiler sounds and mention it at the service
Off-grid homes around Shiplake, Nettlebed and the Chiltern villages
Plenty of homes around Henley-on-Thames aren’t on mains gas, especially in the hamlets and villages up on the Chiltern Hills and along the lanes towards Shiplake and Wargrave. Older farmhouses and cottages often have the oil tank some distance from the house, with long supply pipes running across gardens or yards. Those exposed runs are more vulnerable to the cold.
If your home is down a narrow lane, check the tanker can still reach the fill point in poor weather and order in good time before a cold spell.
Frequently asked questions
Why does my oil boiler keep locking out in winter?
Common causes include a low tank, a blocked filter, air in the fuel line or a worn burner part. Cold weather makes these more likely to show. Reset it once, and if it locks out again, call an OFTEC registered engineer. Repeated resets can make things worse and leave unburnt oil in the boiler.
Can I bleed my oil boiler myself after running out of oil?
It’s best left to an engineer. Bleeding an oil line means working on the fuel system and burner, and getting it wrong can cause leaks, smoke or a boiler that still won’t fire. Once the oil’s delivered, an OFTEC registered technician can bleed the line, check the filter and get the boiler running safely.
Do I need a special engineer for an oil boiler?
Yes. Oil boilers should be serviced and repaired by an OFTEC registered technician, rather than a Gas Safe engineer, unless they hold both. Our team includes Gas Safe registered and OFTEC oil registered heating engineers, so we can work on both gas and oil systems.
Oil boiler playing up?
If your oil boiler isn’t running properly, give us a call on 01491 905375 or drop us a message and we’ll come and find out what’s going on.